Using Your Baby Monitor - Philips SCD488 Mode D'emploi

1 Place both units in the same room to test the connection.
Make sure the baby unit is at least 1 meter / 3 feet away from
the parent unit.
2 Press and hold the On/Off (y) button (A-1) on the baby unit
for 2 seconds.
> The night light (A-3) lights up briefly.
> The LINK light (A-2) lights up red briefly then starts
blinking green as it seeks connection with the parent unit.
3 Press and hold the On/Off button (y) (B-5) on the parent
unit for 2 seconds.
> The sound level lights (B-8) light up orange briefly.
> The battery check light (
> The LINK light (B-7) lights up red briefly then starts
blinking green as it seeks connection with the baby unit.
> The LINK lights (A-2, B-7) on both units blink green until
connection has been established.This will take up to
approximately 30 seconds. Both LINK lights (A-2, B-7) will
then light green continously.
> If, after 30 seconds, no link is establshed both LINK lights
(A-2, B-7) will light up red and the parent unit will emit a
beep from time to time.
4 Position the baby unit at least 1 meter / 3 feet away from
your baby.
5 Position the parent unit at the desired place within the
operating range of the baby unit but at least 1 meter / 3 feet
away from the baby unit. For more information on the
operating range see 'Technical specifications'.
You can now monitor your baby!

Using your baby monitor

- B-6) lights up red briefly.
EN
9