Power Function; The Heat Setting; Automatic Heat Up; Power Management - Electrolux EHH6340FOK Notice D'utilisation

24 www.electrolux.com
• You spill something or put something
on the control panel for more than 10
seconds, (a pan, a cloth, etc.). An
acoustic signal sounds some time and
the appliance deactivates. Remove the
object or clean the control panel.
• The appliance becomes too hot (e.g.
when, a saucepan boils dry). Before
you use the appliance again, the cook-
ing zone must be cool.
• You use incorrect cookware. The sym-
bol
deactivates automatically after 2 mi-
nutes.
• You do not deactivate a cooking zone
or change the heat setting. After some
time
deactivates. See below.
• The relation between heat setting and
times of the Automatic Switch Off func-
tion:
•
,
•
-
•
— 4 hours
•
-

4.3 The heat setting

Touch
Touch
The display shows the heat setting. Touch
and
the cooking zone.

4.4 Automatic Heat Up

You can get a necessary heat setting in a
shorter time if you activate the Automatic
Heat Up function. This function sets the
highest heat setting for some time (see
the diagram), and then decreases to the
necessary heat setting.
To start the Automatic Heat Up function
for a cooking zone:
1.
Touch
in the display.
2.
Immediately touch
comes on in the display.
3.
Immediately touch
again until the necessary heat setting
comes on. After 3 seconds
on in the display.
comes on and the cooking zone
comes on and the appliance
- — 6 hours
— 5 hours
— 1.5 hours
to increase the heat setting.
to decrease the heat setting.
at the same time to deactivate
. The symbol
. The symbol
again and
To stop the function, touch
11
10
9
8
7
6
5
4
3
2
1
0

4.5 Power function

The Power function makes more power
available to the induction cooking zones.
The Power function can be activated for a
limited period of time ( see Technical In-
formation chapter). After that, the induc-
tion cooking zone automatically sets back
to highest heat setting. To activate, touch
,
the heat setting.

4.6 Power management

The power management divides the pow-
er between two cooking zones in a pair
(see the illustration). The power function
increases the power to the maximum level
for one cooking zone in the pair. The
power in the second cooking zone auto-
matically decreases. The heat setting dis-
play for the reduced zone changes be-
tween two levels.
comes on
comes
1 2 3 4 5 6
comes on. To deactivate, change
.
7 8 9