Rx Operating Mode; Functions; Activating Relay Upon Receiving Lock-Release Command - Fermax DUOX Manuel D'installation

DUO DUO DUOX X X X X
DUO DUO
DUO DUO DUOX X X X X
DUO DUO

2.3.2 RX Operating Mode

- The mode where the relay activates the output and the configured command is
received and coincides with the other configured parameters.
- To access this mode configure the bridge to RX mode.

FUNCTIONS:

- Activating relay upon receiving the
- Activation upon
2.3.2.1 ACTIVATION OF THE RELAY UPON RECEIVING LOCK-RELEASE COMMAND
Function description.
You can configure the relay to activate upon receiving a Lock-release command from
residence terminals.
The residence terminals send the lock-release command to the panel upon pressing the
lock-release button. The relay, if configured this way, can be activated upon receiving the
lock-release command. The residence terminals can send the lock-release command to
a specific panel or to all panels in the installation, understanding that this command is
sent individually to each of them.
- The lock-release command, relative to the residence terminals sending them can be
configured as:
* All installed terminals (ALL).
* Terminals from a list (maximum 100 terminals).
* Terminals included within a defined range (consecutive).
- The lock-release command, relative to the panels receiving them can be configured as:
* All panels (they individually receive each command, not all in the group).
For example: In the installation the panels are P1, P2, P3, P4 and P5. The resident
terminal can open the door of Panel P1 or Panel P2 or Panel P3 or Panel P4 or
Panel P5. Upon configuring the lock-release command in All the panels, any time
any panel receives it the relay is activated.
* Only one panel.
For example: In the installation the panels are P1, P2, P3, P4 and P5. The residence
terminal can open the door of Panel P1 or Panel P2 or Panel P3 or Panel P4 or
Panel P5. Upon configuring the lock-release command in a single panel, for ex-
ample, Panel P4, only when Panel P4 receives the command is the relay activated.
Page 10
receiving a call to residence command from a panel.
lock-release command