Lock-Release Function In Configured Panel - Fermax DUOX Manuel D'installation

DUO DUO DUOX X X X X
DUO DUO
DUO DUO DUOX X X X X
DUO DUO
Steps to change the terminal assigned the function.
1. Press the PRG button twice, the D led should light up.
2. Simultaneously press the Min/All and Sec/Single, the D led should remain off.
3. Repeats point 5 and 8 from the previous process.
Notes:
- This function only works with one terminal address. If you need to configure terminals
configured as "ALL," it will not attend to any terminal address.
- In the push-button configuration mode, if no button is pressed the relay returns to standby
and all leds turn off after 300 seconds.

2.3.1.2 LOCK-RELEASE FUNCTION IN CONFIGURED PANEL

Function description.
You can associate the duox relay to a panel so that the Set terminal (button connected
between the SET terminals and -), send a lock-release command to the configured panel.
This function is useful for entrance door buttons far from the street-panel.
Function configuration.
1. Make a call to a telephone in the installation from the panel you want to associate the
relay, and answer.
2. Press the PRG button, the C led should light up.
3. Press the Min/All button, the C LED should blink quickly.
4. Press the Lock-release button on the previously used phone, the C led should turn off.
This way you have already configured the command attending to the relay.
Steps to change the panel assigned the function.
Carry out steps 1 to 4 of the previous process.
Notice:
- In the push-button configuration mode, if no button is pressed the relay returns to standby
and all leds turn off after 300 seconds.
Page 9