Niko 10-363 Information De Produit page 34

10-363
Set ExtU address
Record options
Solely option 4:
Launch programming (Switch programming
mode of the installation on and off again)
Relay switching time
Activate
programming lock
Change master code
Load factory settings
10.5. Switch off programming mode
Leave programming mode
11. USE
11.1. Open door (operating mode code lock)
Start mode
Enter access code
34
Input: 4 ExtU address
BP address = 0 to 63
(FI = 0)
Input: 5 option
Option:
0 Send light switch protocol
1 Accept door opening protocols
2 Restricted
3 Key confirmation tone
4 Switch on programming mode on power supply
and control unit, then start programming
5 Switch operating mode
Input: 8 value
Value = switching time adjustable in steps of 128 ms, 0- ... 250
0 = deactivated
(FI = 24; for approx. 3 sec.)
Input: 10 master code
Master code = max 8 digits
PLEASE NOTE !
the lock cannot be undone manually, only by professionals.
Input: 98 old master code
Master code = max 8 digits
PLEASE NOTE !
for safety reasons the preset master code must be changed when put into service!
Input: 99 master code
Master code = max 8 digits
PLEASE NOTE !
set access codes are deleted
Invoer: 9
Enter access code.
Confirm with .
value
Value:
0 = no, 1 = yes
0 = no, 1 = yes
0 = OFF, 1 = ON
0 = no, 1 = yes
0 = code lock module,
1 = keypad module
new master code
master code
(FI = 1)
(FI = 1)
(FI = 0)
(FI = 1)
(FI = 1)
(FI = 0)
new master code
EN