Beko DV 2570 X Manuel De L'utilisateur page 16

6
Solution suggestions for problems
Drying process takes too much time
• Meshes of the filter may be clogged. Wash with water.
Laundry come out wet at the end of drying.
• Meshes of the filt er may be clogged. Wash with water.
• Excessive laundry might have been loaded in. Do not overload the machine.
Machine does not switch on or the program does not start. Machine is not activated when set.
• It might have not been plugged in. Make sure that the machine is plugged in.
• The loading door may be ajar. Make sure that the loading door is properly closed.
• Program might have not been set or the «Start/Pause/Cancel» button might have not been pressed. Make sure
that the program has been set and it is not in "Pause" mode.
• «Childproof lock» might have been activated. Deactivate the childproof lock.
• The condenser cover on the models with a condenser might not be closed securely. Make sure that the
condenser cover and the red lock is closed securely.
Program has been interrupted without any cause.
• The loading door may be ajar. Make sure that the loading door is properly closed.
• Electricity may be cut off. Press «Start/Pause/Cancel» button to start the program.
• The condenser cover on the models with a condenser might not be closed securely. Make sure that the
condens er cover and the red lock is closed securely.
Laundry has shrunk, become felted or deteriorated.
• A program suitable for the laundry type might have not been used. Dry only the laundry which is suitable for
drying in your machine after checking the labels on your clothes.
• Select a program with suitable low temperature for the laundry type to dry your clothes.
Drum lightning does not come on. (for models equipped with a lamp)
• The machine might have not been started by using the On/Off button. Make sure that the machine is On.
• Bulb may have blown. Call the authorized service to replace the bulb.
• The condenser cover on the models with a condenser might not be closed securely. Make sure that the
condenser cover and the red lock is closed securely.
2 beeps heard when the buttons are pressed or the program selection knob is turned.
• Childproof lock» might have been activated. Deactivate the childproof lock.
• Program selection knob might be turned to an undefined position. Select one of the defined progr ams.
"Filter cleaning" light is flashing.
• Filter might have not been cleaned. Clean the cover filter.
"Final / Anti-creasing" LED is on.
• Program has come to an end. Turn off the machine and take out the laundry.
3 beeps are heard when you press the Start/Pause/Cancel button
• The loading door may be ajar. Make sure that the machine is plugged in.
• Make sure that the condenser cover and the red lock is closed securely.
Also for products equipped with a condenser:
"Water tank" warning LED is flashing.
• Water may be full.
• Drain the water in the water tank.
A
Call an authorised service agent if the problem persists.
16 EN