Maintenance And Cleaning; Lint Filter - Beko DV 2570 X Manuel De L'utilisateur

5

Maintenance and cleaning

Lint filter

Lint and fibres released from the laundry to the air during
the drying cycle are collected in the "Lint Filter".
C
Such fibre and lint are generally formed during
wearing and washing.
C
Always clean the filter after each drying process.
C
You can clean the filter and filter area by vacuum
cleaner.
To clean the filter:
1.Take out the cover.
2.a) If the product's lint filter can be opened as shown in
Figure 1, remove the filter by pulling it up and open
the filter.
2.b) If the product's lint filter is as shown in Figure 2,
remove the filter by pulling it up.
3. Clean lint, fibre, and cotton raveling on the filter and in
the filter housing by hand or with a soft piece of cloth.
4. Close the filter and place it back into its seat.
C
Clogging may arise on the filter surface after using
your machine for some time; if this occurs, wash the
filter with water and dry it before using again.
Figure 1
Figure 2
Sensor (models with a sensor)
There are humidity sensors in your dryer that detect
whether the laundry is dry or not.
To clean the sensor:
1. Open the loading door of the dryer.
2. Allow the machine to cool down if drying has been
carried out.
3. Wipe the metal sensors with a soft cloth, dampened
with vinegar and dry them.
C
Clean metal sensors 4 times a year.
A
Never use solvents, cleaning agents or similar
substances when cleaning since these materials can
cause fire and explosion!
15 EN