Installation And Assembly - Astrapool VICTORIA PLUS SILENT VS Manuel

- Follow the steps below before handling the machine:
1. Disconnect the machine from the mains.
2. Block all start-up devices.
3. Check that there is no voltage in the circuits, even in the auxiliary circuits and additional services.
4. Wait for the impeller to come to a complete standstill.
The list indicated must be used as a guideline and is not binding for safety purposes. There may be particular safety
regulations in specific standards.
- For regular control:
Check that the mechanical parts are tightly secured and check the condition of the screws supporting the
machine.
Check that the power conductors and isolating parts are in their correct position, are secure and in a good
state of repair.
Check the temperature of the machine and the electric motor. In the event of a fault, stop the machine
immediately and contact the nearest Technical Assistance Service.
Check for machine vibrations. In the event of a fault, stop the machine immediately and contact the
nearest Technical Assistance Service.
-Due to the complex nature of the cases treated, the installation, user and maintenance instructions contained
in this manual do not seek to examine all possible and imaginable cases of service and maintenance. Should
you require additional instruction or have specific problems, please do not hesitate to contact the nearest
Technical Assistance Service.
The electrical installation should be done by someone qualified in working with electrical equipment. This equipment
is not designed for those with physical, sensory or mental handicap or people lacking in experience, unless done under
supervision or with instructions of use from a person in charge of safety.
Do not permit children nor adults to sit or lean on the equipment. Children should be supervised to ensure that they do
not play with the equipment.

3. INSTALLATION AND ASSEMBLY

GENERAL
- Our pumps may only be assembled and installed in pools or ponds that are compliant with HD 384.7.702.
Should you have any doubts, please consult your specialist.
- Fit the pump horizontally due to the pre-filter. The pumps are fitted with a pre-filter with a basket inside to
collect any large particles, as they may damage the hydraulic part inside the pump.
- All pumps are fitted with a foot with holes in it to anchor it to the ground (Fig. 1).
Victoria Plus Silent VS - ASTRALPOOL
7