Operating The Cooling Device Safely - Dometic COOLMATIC CD20 Instructions De Montage Et De Service

CD20, CD30
•
Disconnect the cooling device and other power consuming devices
from the battery before connecting a quick charging device.
•
Disconnect the cooling device or switch it off when you turn off the
engine. Otherwise you may discharge the battery.
•
The cooling device is not suitable for transporting caustic materials or
materials containing solvents.
•
The insulation of the cooling device contains flammable cyclopentane
and requires special disposal procedures. Deliver the cooling device
at the end of its life-cycle to an appropriate recycling.
2.2

Operating the cooling device safely

!
CAUTION!
•
Before starting the cooling device, ensure that the power supply line
and the plug are dry.
A
NOTICE!
•
Do not use electrical devices inside the cooling device unless they are
recommended by the manufacturer for the purpose.
•
Do not place the cooling device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
•
Danger of overheating!
Ensure at all times that there is a minimum of 50 mm ventilation on all
four sides of the cooling device. Keep the ventilation area free of any
objects that could restrict the air flow to the cooling components.
Do not place the cooling device in closed compartments or areas with
none or minimal air flow.
•
Ensure that the ventilation openings are not covered.
•
Do not fill the inner container with ice or fluids.
•
Never immerse the cooling device in water.
•
Protect the cooling device and the cable against heat and moisture.
•
For HGV operation:
Empty the coolbox and switch the device off (see chapter "Switching
off the coolbox" on page 13), before the driver's cabin is tipped up.
EN
Safety instructions
9