Publicité
Les langues disponibles
Les langues disponibles
The appliance must be fitted to the wall, respecting the minimum distances as shown in
Fig. 2.
Installing with the moveable support
.- Using the moving support as a template, mark the 4 holes in the wall. Use a spirit
level to ensure the support is completely horizontal.
.- Then drill the 4 holes in the wall using an 8 mm diameter drill. Insert the four bolts with
metal wall plugs.
.- Join by 6 metric screws, the wall heater with the heater body.
.- The appliance fixed carefully, so that it is oriented at 90º (Figure3), if you want to
change the orientation to 75º (Figure 3), change the position of M3 screw located in the
kneecap with a screwdriver.
.- Using the 4 nuts, secure the assembly to the wall. Use the key provided.
IMPORTANT FOR FRANCE:
.- Electrical power connection must be made by cutting off the supplied plug and using
an adequate terminal, as shown below.
Mains supply
L
N
.- In damp areas or outdoor installations, the connection terminal should be installed at
least 25 cm above floor level. Make sure the cable does not touch the ground.
4.
Use of equipment
Connect the plug into the power point. Use the switch (Figure 1F), to connect and
disconnect power to the device.
The led (Figure 1G) indicates if the device is connected.
With the remote control you can turn on and/or turn off each lamp at a distance. Point
the remote control to the control panel (Figure 1E).
Using the control panel switches (Figure 1H) it is also possible to turn the lamps on
and off manually.
Model
HED-1800
Live = Brown
Earth = Yellow-Green
Neutral = Blue
Lamps
Lamp power
2
2 x 900W
9
Device cable
Total power
1.800W
Publicité
