S&P HED-1800 Notice D'installation Et D'utilisation page 10

5. Maintenance
 Before carrying out any maintenance work, make sure that the device has been
disconnected from the mains and let the heater cool down for a few minutes.
 This product does not require special maintenance. It needs to be cleaned periodically
to prevent accumulation of dust on the lamps, as this may cause overheating of the
heater. Clean the lamp with a brush and the body of the product with a damp cloth.
 The replacement of the lamps must be performed by qualified personnel, so contact the
Official Service network of S&P, to ensure adequate technical assistence.
 Do not immerse the device or spray with water.
 If the appliance is not to be used for any length of time, we recommend returning it to its
original package and storing it in a dry, dust-free place.
6. Removal from service and recycling
 EU regulations and our commitment to future generations oblige us to recycle
used materials; please remember to dispose of all unwanted packaging materials at the
appropriate recycling points, and to drop off obsolete equipment at the nearest waste
management point.
7. Technical asistance
S&P's large Technical Service network will guarantee adequate technical assistance.

 If a fault is observed in the unit, please contact any of the mentioned technical service
offices and they will attend to your problem.
 Any manipulation of the appliance by personnel not belonging to the Official S&P
Services will result in your guarantee being void.

For any queries regarding S&P products, please contact any branch of our After Sales
Service network if you are in Spain, or your regular dealer in the rest of the world.
To find your nearest dealer, visit our website at www.solerpalau.com.
THE MANUFACTURER WILL NOT BE HELD LIABLE FOR DAMAGES TO PEOPLE AND/OR
PROPERTY DUE TO NON-COMPLIANCE WITH THESE WARNINGS.
S&P reserves the right to modify the product without prior notification.
10