Training; Start Of Training Session; Training Standby; Training Interrupted - Kettler SE 3610 Mode D'emploi

Training and operating instructions
Gearset 1-20
Small large chain ring
Power mode
Shifting lever
On the left
Switching mode:
change the chain ring
Power mode:
change in power
14
GB
+
+
On the right
Switching mode:
Change the 10 pinions
Power mode:
change in power

Start of training session

Press the SET key to activate the display and exit standby mode.
All segments are displayed briefly followed by the total kilomet-
res covered.

Training standby

The pulse display shows a value or "P" if a pulse value is not
being recorded.
The power value shows 25 watts.
All other values show "0".
The "Gearset with gear 1" mode is displayed or the "Power
mode" is displayed by pressing both the arrow keys at the
same time.

Training

The training session begins when you start pedalling.
The displays for pedalling frequency, speed, distance and time
count up.
The "arrow keys" or gearset switch change the gear or power
value.

Training interrupted

Stop pedalling. Once the pedalling frequency drops below 10
rpm it is recognised that the training is interrupted. The average
values for pedalling frequency, speed, power are displayed
with the Ø symbol.
Pinions 1 - 10