Table des Matières
Publicité
INSTALLATION
!
The Turbo-V controller is equipped with a 3-wire power
cord and plug (internationally approved) for user's
safety. Use this power cord and plug in conjunction with
a properly grounded power socket to avoid electrical
shock.
High voltage developed in the controller can cause
severe injury or death. Before servicing the unit,
disconnect the input power cable.
The Turbo-V controller can be used as a bench unit or
a rack module, but it must be positioned so that free air
can flow through the holes. Do not install or use the
controller in an environment exposed to atmospheric
agents (rain, snow, ice), dust, aggressive gases, or in
explosive environments or those with a high fire risk.
During
operation,
the
conditions must be respected:
•
temperature: from 0 °C to +40 °C
•
relative humidity: 0 - 95%
(without condensation)
To connect the controller to the pump use the specific
cable supplied with the controller.
The controllers model 969-9436 and 969-9536 are
supplide with the pump cable fixed to the controller rear
panel.
See the appendix "Technical Information" for detailed
information about the above mentioned and the other
connections, and about the options installation.
USE
This paragraph describes the fundamental operating
procedures.
Detailed
procedures that involve optional connections or options
are supplied in the paragraph "USE" of the appendix
"Technical Informations".
Make all vacuum manifold and electrical connections
and refer to Turbo-V pump instruction manual prior to
operating the Turbo-V controller.
WARNING!
NOTE
following
environmental
NOTE
information
and
operating
To avoid injury to personnel and damage to the
equipment, if the pump is laying on a table make sure it
is steady. Never operate the Turbo-V pump if the pump
inlet is not connected to the system or blanked off.
The input signal J1 connector should be left in position
including the shipping links if no external connections
are made. The forepump and the Turbo-V pump can be
switched on at the same time.
Controller controls, indicators and connectors
The following paragraph illustrates the Controller
control panel and interconnection panel. More details
are contained in the appendix "Technical Informations".
1. Keyboard push-button for LOW SPEED mode selection. It
is active only when the front panel operation has been
selected. Pressed once, the pump runs at about 2/3 of the
nominal speed. To unselect the mode, press the
push-button again.
2. Keyboard push-button for START, STOP, RESET mode
selection. It is active only when the front panel operation
has been selected. By pressing once the starting phase
begins; if pressed again it stops the pump. If the pump has
been stopped automatically by a fault, this push-button
must be pressed once to reset the controller and a second
time to restart the pump.
3. Keyboard push-button to recall on the display the cycle
number, cycle time and pump life.
4. Keyboard push-button to recall on the display the pump
current, pump temperature, pump power and rotational
speed. It is always active regardless of the operating mode
selected. Push-buttons 3 and 4, if pressed together for at
least 2 seconds, put the controller in a routine where it is
possible to program some operation parameters.
5. LCD back-lighted alphanumeric display: dot matrix 2 lines x
16 characters.
Controller 969-9436,
969-9536 Front Panel
46
INSTRUCTIONS FOR USE
!
WARNING!
NOTE
87-900-907-01 (B)
Publicité
Table des Matières
