Screw Torque Values; Fitting The Stylus And Captive Link - Renishaw TS27R Manuel D'installation Et D'utilisation

1-10
Stylus
Stylus
holder

SCREW TORQUE VALUES

Tighten all the screws to the torque values shown,
remembering to use the support bar whenever
adding or removing parts attached to the break
stem (see page 1-11).
FITTING THE STYLUS
The stylus is retained in the stylus holder by
tightening grubscrew A.

FITTING THE STYLUS AND CAPTIVE LINK

2 mm AF
2.6 Nm
(1.92 lbf.ft)
Break stem
A
2 mm AF
1.1 Nm
(0.81 lbf.ft)
Captive link
CAPTIVE LINK
In the event of excessive stylus overtravel, the
break stem breaks at its weakest point, preventing
damage to the probe mechanism.
The captive link connected to the probe and stylus
holds onto the stylus, otherwise the stylus could fall
into the machine and become lost.
When a new captive link is fitted, it must be bent to
accept screw C (see page 1-11).