Led Light - Bosch B26FT Serie Mode D'emploi

2. Empty the ice cube container and clean with
lukewarm water.
3. Thoroughly dry the container and screw conveyor
to prevent new ice cubes from sticking.
Inserting the ice cube container
4. Push the ice cube container all the way back onto
the supports until it locks into position.
NOTICE
If the container cannot be pushed all the way back,
twist the screw conveyor slightly or remove any ice
cubes that may have stuck to the insertion area.
Removing special humidity filter
(not included on all models)
1. Pull out VitaFresh Pro drawers by approx. 4 inches
(approx. 10 cm).
2. Flip up the glass plate above the VitaFresh Pro
drawers and take them out.
3. Reach between the openings of the cover, carefully
unhook the front 4 notches and pull out the cover.
4. Remove the special humidity filter.
5. Clean the special humidity filter with lukewarm
water and let it dry.
6. Insert the special humidity filter.
7. Reattach the rear of the cover, move it down and
make sure the front part engages.
8. Insert the glass plate and close the VitaFresh Pro
drawers.

LED light

The appliance features a maintenance-free LED light.
When the doors are opened, the interior light
becomes gradually brighter and when the doors are
closed, it gradually dims.
When switched on, the light of the Ice and water
dispenser becomes gradually brighter and when
switched off, it gradually dims.
CAUTION
Risk of eye injury from Class 1M laser light (IEC
60825)!
Do not look directly into the light with optical
instruments.
These lights must be repaired by customer service or
authorized technicians only.
en-us
29