Operation Conditions - Bosch B26FT Serie Mode D'emploi

en-us
Substance
Asbestos
Cyst
Meprobamate
Atenolol
Carbamazepine
DEET
Phenytoin
Metolachlor
Ibuprofen
Trimethoprim
Linuron
Naproxen
Estrone
Bisphenol A
Nonyl phenol
Tested using a flow rate of 0.55 gpm (2.0 L/min), pH of 7.5 ± 0.5, pressure of 60 psig, and temperature of
68 ± 5 °F.
NOTE : The testing was performed under standard laboratory conditions, actual performance may vary.

Operation conditions

Service flow rate
Water pressure
Water temperature
Function
Capacity
Warning: Do not use with water that is microbiologically unsafe or of unknown quality without ad- equate
disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected water that
may contain filterable cyst.
Notice:
n Adsorption media will not be regenerated and used.
Systems must be installed and operated in accordance with manufacturer's recommended procedures and
n
guidelines. The system and installation shall comply with applicable state and local regulations. Install on cold
water line only.
n Flush 3 gallons through filter before use (flush approximately 5 minutes).
To maintain proper filtration, replace the filter at least every 6 months.
n
Manufacturer: Microfilter co.,Ltd.
15-1, GWINONG3-GIL, DEOKSAN-MYEON, JINCHEON-GUN, CHUNG-BUK 27856, KOREA
Phone: +82-43-531-7022/7024
26
Influent challenge
Average reduction
concentration
7 8
10 to 10 fibers/L;
fibers greater than
10 μm in length
minimum 50,000/L
400 ng/L ± 20 %
200 ng/L ± 20 %
1,400 ng/L ± 20 %
1,400 ng/L ± 20 %
200 ng/L ± 20 %
1,400 ng/L ± 20 %
400 ng/L ± 20 %
140 ng/L ± 20 %
140 ng/L ± 20 %
140 ng/L ± 20 %
140 ng/L ± 20 %
2,000 ng/L ± 20 %
1,400 ng/L ± 20 %
WFS200MF 250 gallons (946 L), WFS210MF 150 gallons (567 L)
Reduction
requirement
>99 % 99%
99.99 % 99.95%
>95.2 % N/A
>95.6 % N/A
>98.6 % N/A
>98.7 % N/A
>94.4 % N/A
>98.7 % N/A
>95.3 % N/A
>96.7 % N/A
>96.6 % N/A
>96.2 % N/A
>96.3 % N/A
>99.0 % N/A
>96.3 % N/A
0.55 gpm (2 L/m)
30 psi – 125 psi (206 kPa – 861 kPa)
35 °F – 100 °F (2 °C – 38 °C)
chemical/mechanical
Max. permissible product
water concentration
N/A
N/A
60 ng/L
30 ng/L
200 ng/L
200 ng/L
30 ng/L
200 ng/L
60 ng/L
20 ng/L
20 ng/L
20 ng/L
20 ng/L
300 ng/L
200 ng/L