Siemens sitrans PROBE LU Manuel D'utilisation page 12

Activating SITRANS Probe LU
Keep infrared devices such as laptops, cell phones, and PDAs, away from SITRANS
Note:
Probe LU (PROFIBUS PA) to prevent inadvertent operation.
Power up the instrument. SITRANS Probe LU (PROFIBUS PA) starts in RUN mode, and the LCD
displays the output of AIFB1.
Network Address (default 126)
Verifying/changing the device address via the handheld programmer
Notes:
• Local programming must be enabled, to allow changes (see
page 9).
• CLEAR can be used to clear the field.
C
• Press Right ARROW
• Press Left ARROW
icon is not visible).
1. Press Mode
and open Menu level 1.
2. Press Right ARROW
PROFIBUS Address.
3. Press Right ARROW
mode: the PROGRAM icon will flash.
4. Key in a new value and press Right ARROW
to accept it. (The LCD displays the new value,
PROGRAM icon disappears, and the last menu
digit flashes to indicate Navigation mode.)
5. Press Mode
Performing calibration via PROFIBUS PA
To use PROFIBUS PA, you will need a PC configuration tool: we recommend SIMATIC PDM.
Please consult the operating instructions or online help for details on using SIMATIC PDM. (An
SMPI PROFIBUS PA instruments and SIMATIC PDM
Application Guide
website at: https://pia.khe.siemens.com/index.asp?Nr=11157.)
Page EN-10 SITRANS Probe LU (PROFIBUS PA) – QUICK START MANUAL
to open Edit mode: the PROGRAM icon flashes.
to cancel Edit mode: the Menu number flashes (the PROGRAM
to activate PROGRAM mode
twice to navigate to
again to open Edit
to return to RUN mode.
Local operation enable
Menu level: last
digit flashes in
Navigation mode
Program icon:
flashes in Edit
mode
Right-most digit
flashes in
Navigation mode
is available on our
7ML19985QV81
on