Product Rating Label - Jonsered 500 BAT Manuel De L'utilisateur

B
Product Number . . . . . . . . . . . . . .
Model Number . . . . . . . . . . . . . . . .
Serial Number . . . . . . . . . . . . . . . .
Date of Purchase . . . . . . . . . . . . . .
Place of Purchase . . . . . . . . . . . . .
•PLEASE KEEP PROOF OF PURCHASE•
1. Set the rear wheels
of the mower to
maximum cutting
height.
2. Attach the lower
section of the
handlebar as
illustrated. (C1 &
C2)
3. Insert the bolts
from the inside and
tighten the nuts
from the outside.
NOTE: don't forget
washers.
4. Attach the upper
handlebar. Insert
the bolts from the
inside (C3). NOTE:
place washer
between wing nut
and handlebar.
5. Fit cable clips to
lower handle. (C4)
English - 3

PRODUCT RATING LABEL

Your product is uniquely identified by a
silver and black product rating label. To
ensure you have full product information
when obtaining spares or advice from one
of our approved service centres or if you
need to contact our customer service
department you should make a note in the
space provided of the information shown in
Fig B
ASSEMBLY INSTRUCTIONS
C1
Grass Collector
Assembly
1. Insert steel frame
2. Fit the right and left
C2
3. Raise the safety
C3
C4
4. To empty the grass
D1
into grass collector
bag (D1). Fasten
plastic rails to the
steel frame.
D2
hand pegs of the
grass collector
frame into their
respective ears on
the front section of
the collector.
Secure with "R"
clips. (D2)
D3
flap. Place the
grass collector over
the ejection chute.
Lower the grass
collector until it is
supported by the
lower handle
sections and place
D4
the safetly flap over
the front of the
collector. (D3)
collector, remove
from lawnmower,
open flap and tip
out grass. (D4)