Figure 21. Example Of Bypass Installation - Zodiac AquaPure Ei Série Guide D'installation Et D'utilisation

English
Page 16
nOTE Pool pumps greater than 2 HP may produce flow
rates exceeding 348 L/min (92 gpm). If you are
unsure of the flow rate of your pool pump, contact
your dealer for assistance.
The maximum flow rate for the cell is 348 L/min (92
gpm). If flow rate exceeds 348 L/min (92 gpm), the cell
MUST be plumbed on bypass (see Figure 21). A control
valve must be installed to regulate the flow through the
cell. It can be installed on the inlet side of the cell or
between the inlet and discharge side of the bypass piping.
The proper flow will be achieved by adjusting the handle
of the valve until the red "No Flow" light has turned off
and all large air bubbles are cleared from the cell.
The cell and pod must
be installed as the last
piece of equipment in
the circulation plumb-
ing system just before
the pool.
Control Valve Installation Options
Install between the inlet
and discharge side of
bypass plumbing

Figure 21. Example of Bypass installation

Zodiac AquaPure
®
Heater
Pod
Cell
Install on the inlet side
of the vessel
Pool Return
|
Ei Series APURE35PLGC Installation and Operation Manual
®
Power Pack
To power outlet
Bonding Wire
(to nearest bonding
connector on pool
equipment)
Pump
Filter
Pool Intake Spa Intake
Spa Return