Nilox FOOLISH DUCATI Mode D'emploi page 7

Installation
1. Main body installation
FOOLISH DUCATI can be either handheld or non-hand-held thanks to the combination of various non-hand-held
accessories. The camera can be installed where you want; or it
can be installed in water through the waterproof case in order to photograph scenes in the water.
The installation is shown as follows:
Installation and removal of TFT display screen and main body
TFT Display Screen
** Pull out display screen: Please pull out the display screen after pressing Push key .**
Installation of waterproof case and main body
Main body Waterproof case
Note to use waterproof case
*: Handle with care to avoid any damage to the waterproof case caused by dropping or physical shock.
*: Please clean with clear water as quickly as possible after using and dry it out to avoid rusting.
2. Installation of remote control
There is a separate remote control attached to FOOLISH DUCATI. Please install the remote control onto the correct
position based on the accessories below:
Main body Install TFT display screen into main body
Install main body into Waterproof case
~ 7 ~