Nilox FOOLISH DUCATI Mode D'emploi page 13

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
d.
ln cyclic recording mode, the system will auto save a file every 1 5 minutes
e.
After it is fully charged, it can continuously record time is about 2.5 hours; The continuous voice recording time is
about 3 hours;
f.
ln voice control mode, the system will start recording when the environmental voice is higher than 65dB and the
green indicator will twinkle slowly; if the environmental voice is lower than 65dB and it lasts for 2 minutes, the system
will auto save the 2-minute file recorded, the green indicator will be off, the red indicator will remain bright (the
corresponding record stopping prompt will be displayed on LCD segment screen), and it returns to the preview
state;
g.
To press "+" or "-" key in voice recording mode cannot execute voice increasing/reducing operation; however, to
press "+" or "-" key when recalling audio file can execute voice increasing/reducing operation;
h.
Connect the machine to high-definition display device with HDMI cable in preview state, the basic operation of the
machine can be finished on the high-definition display device; however, the digital zoom function cannot be realized in
720P/960P/1080P mode;
4.
Photo shooting
You can set the image resolution before shooting photos. Press "M" key to enter the setup interface, pres ">
to move the cursor to "
There are three resolution modes available for your selection:
3M: Photo shooting resolution of 2048x1536;
5M: Photo shooting resolution of 2592x1944;
8M: Photo shooting resolution of 3200x2400;
a.
Single shot:
In preview mode, press "Shutter" once to shoot a photo with a "Click" sound, and the frontal red indicator will twinkle
once (the photo shooting icon on LCD segment screen will twinkle once) and it will return to the preview state.
b.
Triple Shot:
Press "M" key to enter the camera setup interface, press ">"or "<" key to move the cursor to "
"Three Photos Continuous Shooting", and press "OK" key to confirm. Press "M" key to exit the setup interface after
setting. Press "Shutter" once at this time, and FOOLISH DUCATI will continuously shoot three photos.
c.
Continuous shoot:
Press "M" key to enter the camera setup interface, press ">" key to move the cursor to "
"Continuous Shooting", and press "OK" key to set the continuous shooting interval time as (0, 2, 3, 5, 10, 20, 30 o 60
second). Press "M" key to exit the setup interface after setting the interval time. Press "Shutter" at this time, and FOOLISH
DUCATI will start shooting one photo every 2s, 3s,5s,10s
d.
Self Shot:
Press "M" key to enter the camera setup interface, press ">" key to move the cursor to "
and press "OK" key to set the delay time as 0s,5s or 10s. Press "M" key to exit the setup interface after setting the delay
time. Press "Shutter" once at this time, and FOOLISH DUCATI will start the timer and shoot a photo at the end of the
delay time.
Nota:
a.
If the memory space gets full, the system will give the message 'Insufficient Memory
and go back to the preview mode;
"; select the menu "Image Resolution", and press "OK" key to enter the resolution setup menu.
20s,30s, till to press "Shutter" key again to stop.
(
~ 13 ~
u
or "<" key
",select the menu
",select the menu
",select the menu "Self-timer",
1
(viewing on TFT display screen),

Publicité

Table des Matières
loading

Table des Matières