Defrost; Stopping Your Product - Beko QZ32 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

the door to open normally after a few
minutes.
You will hear a vacuum sound just after
closing the door. This is quite normal.
months in general in temperatures
under -18°C. Storage periods may
vary depending on the type of the
food. Storage periods of expiry dates
of such food are indicated on the
food package by their manufacturers.
should be placed in the freezer before
they thaw.
compartments with drawers.
To ensure that the high quality achieved
by the frozen food manufacturer and the
food retailer is maintained the following
should be remembered:
1. Put packets in the freezer as quickly
as possible after purchase.
2. Do not exceed "Use By", "Best
Before" dates on the packaging.
3. Please note that drawers, baskets,
flaps, trays are all removable.

Defrost

Increase in the thickness of the ice
that forms on the evaporator of your
refrigerator will decrease the cooling
efficiency of it.
Therefore, you must defrost the ice
when the thickness of the ice layer
around the evaporator reaches to
approximately 5 mm. It is recommended
to defrost the ice when the refrigerator
is not filled too much or is empty.
Wrap the food in the refrigerator by a
few sheets of paper and keep them in
the coolest place possible or in another
refrigerator.
Turn the thermostat setting button to
"off" or unplug the power cable in order
to perform the defrosting.
Remove
refrigerator (it is not required to remove
the lid of the compartment equipped
with a lid). After some time, the water
that melts will accumulate in the
pool located at the bottom of your
refrigerator.
Remove the accumulating water by
means of a soft sponge or etc. and dry
the pool thoroughly.
Do not forget to turn the thermostat
setting button to a position other
than the "off" in order to restart your
refrigerator.
Operate your refrigerator for 2 hours
while it is empty and its doors are
closed before replacing your food into
it.
Check regularly to see if the drain pipe
is clogged or not and clear it with the
stick in the hole when necessary.

Stopping your product

If your thermostat is equipped with
"0" position:
- Your product will stop operating
when you turn the thermostat button to
"0" (zero) position. Your product will not
start unless to you turn the thermostat
button to position "1" or one of the
other positions again.
If your thermostat is equipped with
"min" position:
17
EN
- Unplug your product to stop it.
the
drawers
of
your

Publicité

Table des Matières
loading

Table des Matières