Connecting To Remote Switches For Tone Activation; Installing Selectone Tone Modules - Federal Signal SelecTone Command Units 300VSC-1 Manuel D'installation Et D'entretien

Connecting to Remote Switches for Tone Activation

The 300VSC tones can be activated remotely by any normally open, low-current switch contacts with a
current capacity of at least 50 mA inductive. Figure 4 illustrates the connection of switch contacts to the
300VSC. The designations
switches, program clocks, heat detectors, and smoke detectors. The remotely activated tone sounds as long as
the activating contacts remain closed.

Installing SelecTone Tone Modules

See Figure 4. The 300VSC can accommodate up to four SelecTone tone modules of your choice. To
install the tone modules, insert them into the desired receptacles on the printed circuit board. The
receptacles for TONE 1
TONE 3 module and
1 2 3 4 5 6
Model 300VSC-1 and Model 300VSC-1044SB SelecTone Command Units
S1 S2 S3 S4
, , and
SHOCK HAZARD — Do not perform any installation or maintenance on this
system when power is on. Because the 300VSC does not have a power
switch, ensure that the power is disconnected before proceeding. Failure to
heed this warning may cause serious injury or death.
module and TONE 2
TONE 4 modules are located on the card that plugs into the motherboard.
Figure 4 Remote switch contacts for tone modules 1 through 4
TONE MODULES
TONE 3
TONE 1
7 8 9 10 11 12 13 14 15 16 17
TB1
OPTIONAL REMOTE SWITCH
CONTACTS
(CUSTOMER SUPPLIED)
Installation and Maintenance Manual
represent remote switch contacts such as those found in flow
module are located on the motherboard. Receptacles for
TONE 4
TONE 2
1 2 3 4 5
GND
S1
TONE 1
S2 TONE 2
S3
TONE 3
S4
TONE 4
300VSC-1
REAR VIEW
(WITHOUT COVER)
6 7 8 9 10 11 12 13 14 15 16
TB2
290A7330
13