Center Speaker - Pioneer S-FCRW4500 Mode D'emploi

3. Secure the speaker to the speaker stand with the screws
provided.
Using two large screws for each speaker stand, secure the
speaker to the speaker stand as shown in the illustration below.
4. After you have finished, refer to the other side of this
sheet for the speaker setup options available with this
system.
PLACEMENT AND FINE TUNING
SUBWOOFER
Sound spreads in all directions in the very low frequency
range.Human hearing cannot easily detect the source of very
low frequencies. Be sure to provide a space of at least 8
inches (20cm) between the rear of the subwoofer and the
nearest wall.
FRONT SPEAKERS
For best results the loudspeaker should be positioned near ear
level and the loudspeakers separated a distance approximately
equal to the listening distance.
inward towards the listener will improve the image stability for
non-central listeners. Close proximity to a side or rear wall will
enhance the midbass performance, although too close
(particularly a corner location) and the bass may be unnaturally
high and image performance may be degraded.

CENTER SPEAKER

The loudspeaker should be positioned below the TV. For best
results align the front of the loudspeaker with the front
of the TV. If the loudspeaker is placed under the TV and very
close to the floor, then tilting upwards may be beneficial.
SURROUND SPEAKERS
For best results the loudspeakers should be positioned at or
above ear level. Depending upon your room layout and
preferences, the left and right rear speakers should be
positioned on the side walls just the rear of the listening
position, or on the walls. Place the rear center speaker directly
behind the listening position for best performance.
Angling the loudspeakers
Standard surround 5-spot setup (S-FCRW4500 only)
This is a standard multichannel surround soundspeaker setup
for optimal 5.1 channel home theatre sound.
Center
Front left
Listening position
Surround
left
1. Detach the surround speakers from the front speakers.
To remove, turn the surround speaker so that the
base lines up with the DETACH POSITION (%) on the top of the
front speaker. Once aligned, the surround speaker can be
removed easily by gently lifting it upwards.
2
Caution
To prevent accidents when in use, make sure the surround
speaker is secure by turning it so the
speaker is not in the UNLOCK AREA.
2. Attach the front speaker covers and surround speaker bases.
Line up the holes with the spurs on the cover or base as shown
below. Press in firmly.
3. Attach the non-slip pads to the base of each of the center
and surround speakers.
Use the adhesive to attach 4 pads to the base of each speaker.
www.pioneerelectronics.com
Front right
Subwoofer
Surround
right
arrow at its
1
arrow at the base of the
5ch STEREO
3