Connecting The Speaker Cables - Pioneer PDP-S27-LR Mode D'emploi

2 Attach the speakers to the display.
Install the unit marked "RIGHT" on the right side of the display.
Hexagon socket
head screw
Install the unit marked "LEFT" on the left side of the display.
Plasma display
1 To attach the speakers to the display, start by placing the
upper screw where indicated, tightening until there is a
small space of about 5mm between the head of the screw
and the display.
2 Check the rear of the speakers for the LEFT and RIGHT
indicators to make sure you are attaching the correct
speaker to the corresponding right or left side. Make sure
the UP mark is pointing up, and then attach the speaker
by fitting the upper mounting over the head of the screw
and sliding down until snug.
3 Affix the lower fitting to the display and tighten the screw
about halfway.
4 Adjust the position so that the gap between the speaker
and the display is uniform, and then tighten the screws
firmly.
NOTE:
÷ When the display is to be moved after speaker
÷ The grille nets are designed to protect the speakers,
Plasma display
CONNECTION TO A PLASMA
DISPLAY

1 Connecting the speaker cables

Before connecting the speaker cords, unplug the plasma
display from the power outlet. After you have finished
connecting up, plug the unit back into the power outlet.
1 Connect the input terminals of the speaker system and
1. Push the lever, insert the cable into the hole, and release
2. For the output terminals on the plasma display, push the
Hexagon socket
head screw
÷ After connection to the terminals, pull lightly on the cable
÷ When cable cores stick out and ª and · lines are short-
÷ When the polarity is reversed for one speaker (left or right)
÷ If you insert the speaker cord too far so that the insulation
installation, do not hold the display by the speakers. Hold
the bottom of the display to move it.
however excessive force (such as pushing on, or insert-
ing objects between the grille nets) may result in dam-
age.
the speaker output terminals of the plasma display with
the accessory speaker cable. Make sure the positive (ª)
and negative (·) terminals match when connecting.
the lever.
· terminal (black) ª terminal (red)
White
To the· terminal
(Speaker input terminals of the speaker system)
lever, insert the cable into the hole, and release the lever.
ª ·
R
to confirm that the tips of the cable are properly con-
nected to the terminals. An imperfect connection can
cause sound interruptions and noise.
circuited, an excessive load will be applied to the plasma
display and the operation will stop or trouble will be
caused.
at the time of connection to the plasma display, the bass
reproduction will be reduced, the sound positioning will
be lost, and a correct stereo effect will not be obtained.
is touching the speaker terminal, you may not get any
sound.
< right >
English
Input terminal of speaker
White with gray line
To the ª terminal
Output terminal of plasma
display
< wrong >
3