Installation And Placement; How To Install; When Installing Directly On The Floor; Using The Furnished Speaker Base - Pioneer S-8EX-W Mode D'emploi

Installation and Placement

How to install

Select a desired installation setup from the following.

When installing directly on the floor

Use the furnished spikes when installing the speaker directly on a
floor surface.
Installation
1 Twist the spikes into the threads of the three threaded
metal inserts (M6) embedded in the bottom of the speaker,
and screw down securely.
2 Set the cork pads in the positions where the points of the
three spikes will strike when the speaker is set down.
3 Set the speaker on top of the cork pads.
If you do not use the cork pads when placing the
speakers, the spikes may cause damage to the floor. If
you plan on using the spikes we highly recommend to
use the cork pads.
• As this unit weighs some 28 kg, it is very dangerous to try and
set the spike nut while tilting the speaker. Be sure to place the
unit on a soft area (such as a blanket) so that it does not
damage the floor, and carry out the installation with at least
two people.
6
En

Using the furnished speaker base

When using the furnished speaker base, the use of the furnished
spikes is not required.
Installation
1
locations on the bottom of the base.
Spike
2
places on the top surface of the speaker base.
Bottom of
speaker
3
Affix the furnished non-skid pads (small) to the four
Small non skid-pads
Affix the furnished non-skid pads (large) to the two
Large non-skid pads
Place the speaker on top of the base.
Use of the furnished speaker base allows fine adjustment of
the speaker angle.
Speaker
base
• When using the furnished speaker base, do not fix the speaker
in position with screws. The speaker may fall and cause injury.