GE RARWT1W Manuel Du Propriétaire Et Instructions De Montage page 13

Testing the Thermostat
Furnace Test
1. Toggle mode button until mode is active. Furnace mode
screen is displayed.
2. Adjust set temperature so it is 5 degrees above room
temperature. Within a few seconds, the furnace should initiate
its startup procedure.
3. Adjust the set temperature so it is 2 degrees below the
room temperature and the heat should turn off. Note:
Depending on the model of furnace used, there may be a
delay in engaging and disengaging the furnace.
49-5000400 Rev. 1
13