Ricatech RMC430 Mode D'emploi page 10

CD-RW into the CD Recorder/Player drawer.
2. Press the FUNCTION button /
3. Turn the CD Player on by pressing the CD Power button and press the EJECT button to open the drawer.
4. Load a pre-recorded Audio CD into the CD Player, allowing it to read the disc, and then press the PLAY button.
5. Adjust the sound to the required Volume level. NOTE: This cannot be done once recording has started!
6. Once the CD is ready and playing, press the CD RECORD button /
will begin recording.
7. After recording is completed, press the STOP /
then change to "CD/AUX".
8. Once you have finished the recording, press the FINALIZE /
9. Once the CD has been finalized, the unit will return to CD/AUX mode and the display will show "CD/AUX". The CD
is now ready for playback.
NOTES:If the CD is not finalized, it will not play in any other CD Player.
Not all CD Players are compatible with CD-R or CD-RW's. Check the manual of the other CD player for compatibility.
Recording from Cassettes to CD
1. Load a compatible blank CD-R or CD-RW into the CD Recorder/Player.
2. Press the FUNCTION button /
3. Insert a pre-recorded cassette tape through the CASSETTE DOOR into the cassette deck slot. The Cassette Tape
will start playing.
4. Adjust the sound to the required Volume level. This cannot be done once recording has started!
5. Press the CD RECORD button /
6. Once the first side of the Cassette has finished, press the STOP /
a few seconds and then change to "PHONO".
7. Eject the cassette tape and flip it over to the other side.
8. Repeat steps 5 - 6 to record the other side of the cassette.
9. Once you have finished the recording, press the FINALIZE /
10. Once the CD has been finalized, the unit will return to Phono mode and the display will show "PHONO". The CD is
now ready for use and can be played back.
NOTES: If the CD is not finalized, it will not play in any other CD Player.
Not all CD players are compatible with CD-R and CD-RW discs. Check the manual of other CD player for compatibility.
Recording from Radio to CD
1. Load a compatible blank CD-R or CD-RW into the CD Recorder/Player.
2. Press the FUNCTION button /
3. Press the BAND button /
4. Select the desired radio station by rotating the TUNING KNOB.
5. Adjust the sound to the required Volume level. This cannot be done once recording has started!
6. Press the CD RECORD button /
7. After recording is completed, press the STOP /
then change to "Tuner".
to set the unit to CD/AUX MODE.
button. The display will read "CLOSE TK" for a few seconds and
to set the unit to PHONO MODE.
―Record‖ will flash on the LCD. The CD will begin recording.
to select TUNER MODE.
to select the desired tuning band (AM or FM).
- ―Record‖ will flash on the LCD and the CD will begin recording.
button. The display will show "CLOSE TK" for a few seconds and
. "Record" will show on the LCD and the CD
button. The display will show "Finalize".
button. The display will read "CLOSE TK" for
button. The display will read "Finalize".