Promac SY-315 Mode D'emploi page 8

- Place the machine on the top of the stand.
- Align the four holes (G) on the lower face of the
machine.
SY-315 / SY-315L
- Screw the spacer bolts into the threaded holes (G).
- Screw the nuts to the threaded holes and secure.
Install the coolant support:
- Attach the support plate (H) with 2 bolts M8x12 (I) like
shown in the picture.
Remove the oil fill transport plug (J) (only used for transport)
from gear transfer case.
Turn the control handle (L) with trigger switch (K) into the
threaded hole (J) and secure with nut in correct position.
8