Operating Instructions - Leonard LAS6060F Notice D'utilisation

OPERATING INSTRUCTIONS

Activation and deactivation
Touch for 1 second to activate or deac-
tivate the appliance.
Automatic Switch Off
The function deactivates the appliance
automatically if:
• All cooking zones are deactivated
• You do not set the heat setting after you
activate the appliance.
The times of Automatic Switch Off
Heat setting
The cooking
zone deacti-
vates after
The heat setting
Touch to increase the heat setting.
Touch to decrease the heat setting. The
display shows the heat setting. Touch
and at the same time to deactivate the
cooking zone.
Activation and deactivation of the outer
rings
You can adjust the surface you cook to the
dimension of the cookware.
To activate the outer ring touch the sensor
field / . The indicator comes on. For
more outer rings touch the same sensor
field again. The subsequent indicator
comes on.
Do the procedure again to deactivate the
outer ring. The indicator goes out.
.
, -
6 hours 5 hours
• You spill something or put something on
the control panel for more than 10 sec-
onds, (a pan, a cloth, etc.). The sound
operates some time and the appliance
deactivates. Remove the object or clean
the control panel.
• You do not deactivate a cooking zone or
change the heat setting. After some time
comes on and the appliance deacti-
vates. See the table.
-
4 hours
Automatic Heat Up
11
10
9
8
7
6
5
4
3
2
1
0
1 2
You can get a necessary heat setting in a
shorter time if you activate the Automatic
Heat Up function. This function sets the
highest heat setting for some time (see the
illustration), and then decreases to the nec-
essary heat setting.
To start the Automatic Heat Up function the
cooking zone must be cold (no
display). Touch
again and again until the necessary heat
setting comes on. After 3 seconds
comes on in the display.
To stop the function touch
leonard 15
-
1.5 hours
3 4 5 6 7
in the
of the cooking zone
.
8 9