D1 Starting; User Instructions; Control Panel - Electrolux Veetsan VDU30 Manuel D'installation, Emploi Et Entretien

D
Our appliances have been studied and optimized to give the highest performance. This appliance must be used exclusi-
vely for the purpose for which it has been designed, i.e. for washing dishes with water and specific detergents. Any other
use will be considered "improper use" and will void the warranty and manufacturer liability.
This appliance will not carry out the rinse cycle should there be no supply water; it stops all functions and an error mes-
sage "A1" will be displayed (also see "Warning Messages Displayed On The Control Panel").
• Carry out a couple of cycles without dishes to flush out any industrial grease which have remained in the tank
and piping.
• Avoid washing decorated dishes.
• Do not allow silverware to come into contact with other metals.
• Do not allow food to dry on the dishes.
• Remove large food scraps from the dishes to prevent clogging the filters.
• Pre-wash the dishes by spraying them with cold or lukewarm water, do not use any detergent.
• Use automatic dispensers for the detergent.
• If there is no automatic dispenser, pour a non-foaming detergent into the tank when the water has reached the
washing temperature.
LEGEND:
A = ON/OFF
B = Drain/self-cleaning cycle
K = Display
D = "Tank temperature" indicator light
The temperature shown on the display is that of the boiler if the indicator light "E" is on or of the tank if the light "D" is on.
The tank temperature is displayed during the wash cycle and the boiler temperature during the rinse cycle.
D1 STARTING
• Open the water supply shutoff valve.
• Switch unit on at the main circuit breaker.
• Open the door and check that all the components are
in their correct position.
• Close the door and press ON/OFF "A" button.
The indicator light of the ON/OFF button "A" (Figure 14)
comes on, indicating that the dishwasher is powered and
that water is being introduced and heated.

USER INSTRUCTIONS

CONTROL PANEL

A B K
TIPS
D E F G
E = "Boiler temperature" indicator light
F = Wash cycle 1
G = Wash cycle 2
Figure 14
The word "FILL" is shown on the display during the entire
filling and heating stage
Notice, this dishwasher does the first tank filling through
several consecutive hot rinse cycles, while the display
shows the message FILL (scrolling across display). This
system save up to 30% in time over traditional models. If
the door is opened during this stage the message
"CLOSE" will scroll on the display:


13