C4 Detergent/Rinse-Aid Dispensers And Settings - Electrolux Veetsan VDU30 Manuel D'installation, Emploi Et Entretien

TANK WATER LEVEL TOO HIGH
B2
- Check for obstruction on the waste outlet pipe and
the overflow aperture.
CALL THE AUTHORIZED SERVICE CENTER
C1..C8
CALL THE AUTHORIZED SERVICE CENTER
E1..E8
- The appliance continues to operate, but appropriate
checks by an authorized technician are recommen-
ded.
C4 DETERGENT/RINSE-AID DISPENSERS AND
SETTINGS
If the appliance is connected to a water softener or
osmotic device, contact the detergent supplier for the
specific product.
Peristaltic dispensers (rinse-aid and detergent) require
periodic maintenance. The internal hose of the rinse-aid
dispenser should undergo periodic maintenance (at
least once or twice a year).
1. Dishwasher with incorporated detergent dispen-
ser pump (Figure 11).
Pump "R" dispenses about 0.021 oz per second /0.6 g
per second of detergent. When the appliance is filled
with water for the first time in the day, it dispenses
1.058oz/30g of detergent in 50 sec., thereby providing a
concentration of 0.046 oz per quart/1.3 g per liter. Pump
"R" dispenses 0.126 oz/3.6 g in 6 sec. at each cycle.
Dispenser operating time may be changed, following the
instructions given in the next paragraph.
Insert the hose provided in the kit into the detergent con-
tainer.
2. Dishwashers with incorporated peristaltic rinse-
aid dispenser pump (Figure 11).
Pump "S" dispenses about 0.0046 oz per second/0.13 g
per second of rinse-aid. It dispenses 0.014 oz/0.39 g in 3
sec. at each rinse.
Dispenser operating time may be changed, following the
instructions given in the next paragraph.
Insert the hose provided in the kit into the rinse-aid con-
tainer .
10
Connections for automatic detergent dispenser
(Figure 11)
P
R
S
Figure 11
There is a ready-made impression "N" (inside dishwa-
sher chamber floor) to be perforated (5/16"dia/8mm) for
positioning the detergent concentration measuring sen-
sor.
Inside the tank there is a hole "P" (3/8"dia/10mm) closed
with a plug, which may be used for mounting a liquid
detergent injector.
The sensor and liquid detergent injector should be instal-
led without compromising the watertightness of the
appliance.
Electrical connections for automatic detergent and
rinse-aid dispensers.
Terminals are available on the power supply terminal box
for the electrical connection of external dispensers wor-
king at 208V or 240V. Max. power 30 VA.
Figure 12
Connect the detergent dispenser between terminals 7
and 9. These connection points are live for a set time
during filling of the tank and at the start of the wash cycle
(see paragraph "Setting the dispensers").
N
L1
L2
L3