C5 Setting The Dispensers - Electrolux Veetsan VDU30 Manuel D'installation, Emploi Et Entretien

8
9
Figure 13
Connect the rinse-aid dispenser between terminals 8
and 9. These connection points are live during filling of
the tank and at the end of the rinse cycle for a set time
(see "setting the dispensers" paragraph).
MANUAL ACTIVATION
Whenever the detergent containers are replaced, it may
be necessary to activate the dispensers manually in
order to fill the hoses and eliminate any air.
Simultaneously press the buttons, as shown in the figu-
res below. If necessary, repeat this operation several
times.
DETERGENT DISPENSER
C5 SETTING THE DISPENSERS
All operations should be carried out with the appliance
switched on, the door open and no cycle selected.
LEGEND
Increase
Decrease
Confirm or select next parameter
SEQUENTIAL START
Press the indicated buttons simultaneously for 5
seconds:
DISPENSER RINSE-AID

Display of programming mode:

Initial amount of detergent:

Setting the activation time:

Initial amount of rinse-aid:

Setting the activation time:

Amount of detergent during the cycle:

Setting the activation time:

Amount of rinse-aid during the cycle:

Setting the activation time:

Exit from programming mode:

11