D6 Residual Risks; Residual Risks - Electrolux Veetsan VDU30 Manuel D'installation, Emploi Et Entretien

Prolonged period of inactivity
If the dishwasher is not to be used for a long time, pro-
ceed as follows:
• Close the water supply shutoff valve.
• Completely drain the tank.
• Remove and carefully clean the filters.
• Completely drain the incorporated dispenser hoses,
removing them from the containers. Repeat the pro-
cedure described in the paragraph "Manual activa-
tion" at least 3 times.
• Completely drain the boiler by simultaneously pres-
sing the buttons as shown in the figure.
A buzzer indicates completion of drainage.
• Spread a thin film of petroleum jelly over all the stain-
less steel surfaces.
Preventive maintenance
The preventive maintenance message "CALL" may be
activated.
Upon reaching the set number of cycles (e.g. 20000),
appears on the display.
This message advises calling a qualified authorized ser-
vice technician for a general check-up on of the state of
the appliance.
NOTICE: CONTACT YOUR AUTHORIZED SERVICE
COMPANY TO PERFORM
REPAIRS
NOTICE: Using any parts other than genuine factory
manufactured parts relieves the manufacturer of all war-
ranty and liability.
NOTICE: Manufacturer reserves the right to change spe-
cifications at any time without notice.
WARNING: The equipment warranty is not valid unless
the appliance is installed, started and demonstrated
under the supervision of factory trained installer.
WARNING: The unit must be installed by Personnel who
are qualified to work with electricity and plumbing.
Improper installation can cause injury to personnel
and/or damage to the equipment. The unit must be
installed in accordance with applicable codes.
D6

RESIDUAL RISKS

The machine has several risks that were not completely
eliminated from a design standpoint or with the installa-
tion of adequate protection devices.
Nevertheless, through this manual the Manufacturer has
taken steps to inform operators of such risks, carefully
indicating the personal protection equipment to be used
by them.
MAINTENACE AND
Sufficient spaces are provided for during the machine
installation phases in order to limit these risks.
To preserve these conditions, the corridors and areas
around the machine must always be:
• kept free of obstacles (e.g. ladders, tools, containers,
boxes, etc.);
• clean and dry;
• well lit.
For the Customer's complete information, the residual
risks remaining on the machine are given below; such
actions are to be considered incorrect and therefore
strictly forbidden.
RESIDUAL DESCRIPTION OF HAZARDOUS
RISK SITUATION
Slipping or The operator can slip due to water or
falling dirt on the floor.
Burns The operator deliberately or uninten-
tionally touches some components
inside the machine or dishes at the
outfeed without using gloves or with-
out allowing them to cool. Possible
contact with water above 60°C /
140°F.
Electrocution Contact with live parts during main-
tenance operations carried out with
the electrical panel powered.
Falling from The operator intervenes on the
above machine using unsuitable systems
to access the upper part (e.g. rung
ladders, or climbs on it).
Tipping of During maintenance on the machine
loads or the
machine with the use of unsuitable
accessories or lifting systems or with
load unbalanced.
Chemical Contact with chemical substances
(e.g. detergent, rinse aid, scale
remover, etc.) without taking ade-
quate safety precautions. Therefore
always refer to the safety cards and
labels on the products used.
packing containing the
17