Door Tension Adjustment; Base And Toe Panel - Gaggenau GI240760 Mode D'emploi

ELECTRICAL CONNECTION (continued)
Figure 25

DOOR TENSION ADJUSTMENT (

BASE AND TOE PANEL

A
B
Figure 27
1/8"
3mm
Figure 26
WARNING: FIRE HAZARD - loose or
improper electrical connections can cause
fire. Make certain that all electrical
connections are properly made.
• Do not pre-twist the wires before connecting
them with wire nuts.
• Extend the dishwasher's stranded wires 1/8"
(3mm) beyond the power supply cable's solid
wires, as shown in Figure 25.
5. Using the supplied wire nuts, connect the electri-
cal supply wires to the dishwasher's wires, black
to black, white to white, and green or bare to
green or bare. Make certain that the insulated
wires show no bare wire from the bottoms of the
wire nuts. Gently tug the wires to make certain
they are securely connected.
6. Press the wires into the junction box. Make certain
that the wire nuts do not loosen.
7. Place the cover on the junction box and secure it
to the junction box with the supplied screw.
GI 240-760 and GI 230-760)
After the dishwasher is installed, open and close the
door several times to make sure that it does so with
ease. If the door closes too quickly or if the door falls
open, the spring tension needs to be adjusted.
To Adjust the Spring Tension:
1. Obtain the provided Door Tension Screws (Figure
1, letter J) from the parts bag.
2. Insert the screws as shown in Figure 26. Turning
the screw clockwise increases the spring tension.
Turning the screws counter-clockwise decreases
the spring tension.
Regular Toe Panel Installation
For GM 240-730 only:
1. Obtain the Toe Panel Brackets and the Toe Panel
Bracket Screws from the Dishwasher Installation
Kit bag (see figure 1).
2. Insert screws through the Toe Panel Bracket (see
Figure 27, letter A).
3. With a Torx screwdriver, fasten screws and the Toe
Panel Bracket onto the dishwasher base.
For all dishwasher models, including GM 240-730:
4. Obtain Toe Panel Screws from the Dishwasher
Installation Kit bag (see Figure 1).
5. Insert screws through the Toe Panel (see Figure
27, letter B).
6. With a Torx screwdriver, fasten screws and toe
panel into dishwasher base.
13