Placing The Dishwasher; Securing The Dishwasher - Gaggenau GI240760 Mode D'emploi

PLACING THE DISHWASHER

Figure 15
CAUTION:
Do not
remove
styrofoam
blocks
until the
unit is
installed.
C

SECURING THE DISHWASHER

14"
(355mm)
21"
(533mm)
A
Figure 16
B
Figure 17
A
B
Figure 18
CAUTION: Danger - the door on the GM
models is very heavy which can cause the
unit to tip over. Do not remove the styro-
foam blocks show in Figure 16 until the unit
is secured to the cabinet. Do not open the
door until the unit is installed.
1. Straighten and position the hot water supply line
and the electrical supply cable as shown in Figure
15 so that they will align with their channels under
the dishwasher base.
2. Position the dishwasher close enough to the
enclosure so that you can run the dishwasher
drain hose to the under sink drain connection.
Make certain that the hot water supply line and the
electrical supply cable are in their channels under
the dishwasher base, as shown in Figure 16,
letter A.
3. Place the dishwasher directly in front of the
enclosure.
4. Perform a level check as shown in Figure 16.
Adjust the rear leveler by turning the center screw
at the front of the dishwasher, as shown in Figure
17, letter B. Turning the screw clockwise raises
the rear of the dishwasher. Adjust the front
levelers by turning them with a screwdriver, as
shown in Figure 17, letter C. Turning the levelers
to the right raises the dishwasher. If additional
height is needed, shims may be added under the
leveler feet.
5. Push the dishwasher into the enclosure.
Drive the mounting screws through the holes in the
mounting brackets, as shown in Figure 18, letter A
for Top Mount, or as shown in Figure 18, letter B for
Side mount.
9