DeWalt DXDP710140 Manuel D'utilisation page 5

English
WARNING:
The tape layers will start to self-merge
immediately with permanent adhesion within 24 hours.
Repositioning is not recommended. Even though the
silicon tape may be used under wet or oily conditions,
an application on a clean, dry surface is recommended.
The tape is not reusable, but additional tape layers can
be added at any point in time. After application and
curing time, always check the strength of the application
by testing it with a 3 lbs./1.36 kg. load. Perform this test
before every use.
a ) Clean the surface to be used and cut a piece of the tape
to the desired length (i.e. from one point to another it should
have at least 10 loops for proper grip). The length should be
adjusted based on the size of the tool/handle.
b ) Make the 1st winding around the handle holding the
tape in position and rolling it around the desired part
(handle + attachment D-ring) until the tape is doubled over
itself. This initial winding tape on tape will help to secure the
future layers.
c ) Ensure that constant tension is maintained as
subsequent layers of tape are applied and that each new layer
partially covers both the bare part and the prior layer of tape.
This overlapping will help the tape to self-merge. The stretch
should be 40 to 50% of the remaining length of the tape; this
stretching ensures the application will hold.
d ) The tape must be wound at minimum over the entire
length of the attachment D-ring in one direction and
covered a second time over itself in the other direction. The
last layer of tape must be wound completely over the previous
layer without overlapping. Maximum tension is not
necessary on the last layer.
e ) Do not flex the tape too much as it may break.
6
WIRE TOOL ATTACHMENT
MAX
2
2
0,91 kg
MAX
2
2
DXDP710700
LBS
0.91 kg/
WIRE TOOL ATTACHMENT MAX
3
3
1,36 kg/
MAX
3
3
DXDP710710
LBS
1,36 kg/
Steps to use wire tool attachment DXDP710700
LBS
Identify the tool with captive eye
(e.g. Utility knife).
Steps to use wire tool attachment DXDP710710
LBS
Open the attachment gate.
Identify the tool with
captive eye (e.g. Torpedo
Pass it through the captive
Level).
eye.
English
First pass the loop through
the captive hole of the tool
and pass wire attachment
end through the tool
attachment loop forming
a knot on the captive eye.
Tightly lock the knot with
wire attachment.
The wire tool attachment is
ready for use.
Close the attachment gate.
The wire tool attachment is
ready for use.
7