Safety Shut-Off; Technical Data - Stiebel Eltron SHC 2.5 Mode D'emploi Et Directives D'installation

INSTALLATION

TECHNICAL dATA

6 Fit a new anode rod including the sealing gasket and sup-
porting washer into the tank opening and secure it with the
included washer and nut. Use a tightening torque of 1100
N•cm ±120 N•cm.
7 Refit all the wires and the heating element.
8 Refill the water heater with water and check for leaks before
connecting the power.

11.9 Safety Shut-off

WARNING:
!
Never lock the sliding reset plunger.
DANGER:
Water temperatures over 125°F (52°C) can cause se-
vere burns instantly or death from scalding. Do not
attempt to reset the high limit switch without first
cooling down the water inside the water heater.
11.9.1 Resetting high temperature shut-off system
1 Unplug the water heater.
2 Remove the cover. See 11.4, "Removing the cover", pg. 7.
3 Unplug the adapter (1) from the controller shaft.
4 Press in button (2) with an appropriate tool.
5 Reassemble the adapter in the correct position.
6 Reassemble the cover of the heater and tighten.
7 Reassemble the thermostat control knob.
WWW.STIEBEL-ELTRON-USA.COM
1 2
1 Adapter
2 Button
12. Technical Data
SHC 2.5
Item No. 233219
Voltage 110–120 V
Wattage 1300 W
Amperage 11.3 A
Phase Single, 1/N/PE
Frequency 50/60 Hz
Type of installation Under sink
Internal tank material Steel
Enclosure material Plastic
Thermal insulation Polystyrene
material
Color white
Nominal water volume 2.65 gal / 10 l
1
Standby energy loss 0.37 kWh/day
Recovery time 18 minutes
Temperature setting 86–140 °F / 30–60 °C
range
Max. operating 150 psi / 1.0 MPa
pressure
Weight empty 15.9 lbs / 7.2 kg 19.8 lbs / 9.0 kg
Weight full 38.6 lbs 17.5 kg 52.9 lbs / 24.0 kg 76.3 lbs / 34.6 kg
Water connections 1/2˝ NPT
1
Measured at 131°F / 55°C set point temperature in 68°F / 20°C ambient air temperature.
SHC 4 SHC 6
234046 235089
4 gal / 15 l 6 gal / 22.7 l
0.39 kWh/day 0.47 kWh/day
27 minutes 45 minutes
26.2 lbs / 11.9 kg
SHC 2.5 / SHC 4 / SHC 6 | 9