Register Your Product; General Description; Technical Description; General Recommendations - Stiebel Eltron SHC 2.5 Mode D'emploi Et Directives D'installation

OPERATION

REGISTER yOUR PROdUCT

3. Register your product
NOTE:
You must register this product within 90 days of
purchase on our web site in order to activate any
standard warranty or to be eligible for the extended
warranty. Go to our website at:
www.stiebel-eltron-usa.com and click on "Register
Your Product".
Before beginning the registration process, we suggest
that you gather the necessary information as follows:
Model, Example: SHC 2.5 (from the label that is on the
top of the unit in the center)
Number listed after "Nr."
Place of Purchase
Purchase Date
First & Last Name
Email address
Physical Address
Phone Number
If you have any questions concerning the registration
process or warranty options, please contact Stiebel Eltron
USA directly at (800)-582-8423.
4.

General Description

These SHC water heaters can be used in most point-of-use ap-
plications. They are designed to supply hot water for hand wash
and kitchen sinks in a residential, commercial or industrial en-
vironment.
These water heaters can replace traditional hot water systems
which consist of a central hot water heater with hot water piping
going to several draw-off points.
The SHC water heaters are lightweight and compact and manufac-
tured for easy installation. The units are designed to be mounted
on the wall. These units are designed to operate under normal
street water pressure.
5.

Technical Description

The pressure vessel of the water heater is welded glass-lined steel
and is equipped with a sacrificial anode rod. The thermal insula-
tion is made of polystyrene.
The water heater is equipped with both a thermostat and a high
limit temperature switch. A temperature/pressure relief valve is
supplied with the unit.
4 | SHC 2.5 / SHC 4 / SHC 6
6.

General Recommendations

The installation must be carried out by licensed professionals. All
state and local codes must be adhered to.
The manufacturer will not be liable for any damages because of
failure to comply with these installation instructions or because
of improper installation performed by an unqualified installer.
NOTE:
!
The T&P valve must be manually vented monthly. See
11.2, "Venting the T&P relief valve", pg. 7.
NOTE:
!
Choose a location that allows easy access for mainte-
nance or servicing.
The water heater should be installed with at least
8˝ (203 mm) of clearance on the top and sides of the
unit.
WWW.STIEBEL-ELTRON-USA.COM