Safety Precautions; Test Symbols; Register Your Product; General - Stiebel Eltron TEMPRA® 12 B TEMPRA 15 B Utilisation Et Installation

OPERATION

REGISTER YOUR PRODUCT

If you have any questions regarding the installation, use or opera-
tion of this water heater, or if you need any additional installation
manuals, please call our technical service line at (800)-582-8423.
2.3

Safety Precautions

DANGER: Injury
!
Please read and follow these instructions. Failure to
follow these instructions could result in serious per-
sonal injury or death.
Damage to the appliance and the environment
!
The appliance must be installed by a licensed electrician
and plumber. The installation must comply with all na-
tional, state and local plumbing and electric codes.
Service of the appliance must be performed by qualifi ed
service TECHNICIANS.
DANGER: Electrocution
!
Before proceeding with any installation, adjustment.
Alteration, or service of this appliance all circuit
breakers and disconnect switches servicing the appli-
ance must be turned off. Failure to do so could result
in serious personal injury or death.
DANGER: Electrocution
Never remove the appliance's cover unless the elec-
tricity servicing the appliance is turned off. Failure to
do so could result in personal injury or death.
DANGER: Electrocution
The appliance must be properly grounded. Failure to
electrically ground the product could result in serious
personal injury or death.
DANGER: Burns
Water temperatures over 125 °F (52 °C)can cause
severe burns instantly or death from scalding. A hot
water scalding potential exists if the thermostat on
the appliance is set too high. Households with small
children, disabled or elderly persons may require that
the thermostat be set at 113 °F (45 °C) or lower to
prevent possible injury from hot water.
WARNING: Injury
where children or persons with limited physical, sen-
sory or mental capabilities are to be allowed to con-
trol this appliance, ensure that this will only happen
under supervision or after appropriate instructions by
a person responsible for their safety. Children should
be supervised to ensure that they never play with the
appliance.
2.4

Test symbols

See the type label on the appliance.
WWW.STIEBEL-ELTRON-USA.COM
3. Register your product
You must register this product within 90 days of pur-
chase on our web site in order to activate the standard
warranty or to be eligible for the extended warranty.
Go to our web site at
www.stiebel-eltron-usa.com and click on register
your product.
Before beginning the registration process, we suggest that
you gather the necessary information which will be as
follows:
Type, Example: Tempra 24 Plus (from the label that is on the
unit)
Number listed after "Nr."
Place of Purchase
Purchase Date
First & Last Name
Email address
Physical Address
Phone Number
Installation Date
IF YOU HAVE ANY QUESTIONS CONCERNING THE REGISTRA-
TION PROCESS OR WARRANTY OPTIONS, PLEASE CONTACT
STIEBEL ELTRON USA DIRECTLY AT (800)-582-8423.
4.

General

DANGER: Burns
!
Water temperatures over 125 °F (52 °C) can cause
severe burns instantly or death from scalding. A hot
water scalding potential exists if the thermostat on the
appliance is set too high. Households with small
children, disabled or elderly persons may require that
the thermostat be set at 113 °F (45 °C) or lower to
prevent possible injury from hot water.
The Tempra B and Tempra Plus units are designed to supply hot
water for a house, apartment or certain commercial applications.
Unlike a conventional storage type water heater the Tempra tank-
less water heater does not store hot water. Instead, water is heated
instantaneously as it fl ows through the unit. The Tempra offers
greater energy effi ciency than storage type water heaters due to
the absence of stand-by losses and reduced hot water pipe runs.
The input of heat into the water is controlled electronically. The
Tempra will deliver any water temperature between 86 °F (30 °C)
and 140 °F (60 °C). Please set the desired temperature using the
knob on the front cover. The Tempra Plus Temperature adjustment
knob can be set to: OFF, 86...140 °F (30...60 °C).
The Tempra B has a °F and a °C scale. The output temperature of
the Tempra Plus is shown in the digital display in °F or °C units.
(°F or °C units can be selected during installation, factory setting:
°F). The maximum temperature is electronically limited to 140 °F
(60 °C).
TEMPRA & TEMPRA PLUS | 3