Applications - Honeywell evotouch Installation

Guided Configuration
Guided Configuration is the recommended
option the first time you configure evotouch,
as it leads you through the essential steps in
setting up a system.
• At the prompt press YES to proceed.
Heat demand control
The first step is to specify whether the
system includes a heat demand boiler:
• Press NO or YES as appropriate.
If you pressed YES proceed as follows.
If you pressed NO skip to the section
Applications below.
If the system includes heat demand control,
the next step is to configure the wireless link
to the boiler controller:
• Press BIND.
For information about binding see Binding
on the previous page.
• When binding is successful press NEXT.
The following prompt is displayed:
• Install the demand device in its proper
location and put the device into the test
mode.
• Press NEXT when ready.
The following prompt is displayed:
• Press NEXT.

Applications

The following menu allows you to specify
which other components in the system need
to be configured:
• Select the type of application you are
configuring.
7