Editing Names - Honeywell evotouch Installation

Configuration – General Features
Binding
Guided Configuration binds each of the
control devices and sensors to evotouch, to
ensure that the wireless communication is
working correctly.
After binding each device, a prompt
shows whether binding was successful; for
example:
Binding can fail for the following reasons:
- The device is not switched on.
- The device is too far away.
- There are too many solid objects in the
path to the device.
Correct the problem and try again.

Editing names

During configuration you are given the
option of editing the names used to identify
the zones in the system. These are the
names seen by the user on the main Home
screen.
To edit a name the following screen is
displayed:
6
• Press  to delete characters.
• Press ABC to enter upper-case letters,
abc to enter lower-case letters, or 123 to
enter digits.
• Press the blank key to enter a space.
• Press DONE when finished.
Configuring mixed applications
The Guided Configuration described on the
following pages assumes all your zones use
the same type of control. If you have a mixed
application, such as 5 zones with radiator
control and 3 zones with underfloor heating
control, you can set up the configuration as
follows:
• Use the Guided Configuration to
configure the 5 zones for radiator control.
• Use the ADD ZONE option to add the
3 zones for underfloor heating control;
see Adding a zone, page 9.
• Finally use the SYSTEM
CONFIGURATION menu BINDING AND
RF TEST option, doing the RF test for
each zone. For more information see the
Extended Installation Guide.