Troubleshooting; All Functions - American Standard INAX SpaLet Manuel D'installation Et De L'utilisateur

Troubleshooting

You can easily correct some of the problems with this product. Before requesting repairs, please check the
following items.
If you are unable to correct the problem using the troubleshooting procedures shown below, please contact
your local customer service representative.

All functions

Symptom
The system will not operate
at all.
Posterior cleansing and Feminine cleansing
Symptom
Water does not
spray out.
Symptom
Spray water is not warm.
Cause
Electricity is not being supplied to
the power outlet.
The power switch is off. The LED
on the indicator panel is off.
The power plug is not plugged into
the wall outlet.
Cause
The water shutoff valve is closed.
The inlet strainer is clogged.
Tap water pressure is low. Spray
strength is set to "Lo" .
The seat sensor is not engaged.
Cause
Water temperature is not set to an
appropriate temperature.
The Cleansing or bidet function
was used for a long period of time.
ECO mode is activated.
Check for a power failure or tripped breaker,
etc.
Press the STOP button for 2 seconds to verify
the LED lights on the seat unit light up.
Plug the power plug into the wall outlet.
Turn the water shutoff valve counterclockwise.
Clean the inlet strainer.
Set the spray strength to a higher level.
Sit back fully on the toilet seat.
Adjust the water temperature to the
appropriate level.
The water takes about 3 minutes to warm
back.
Disable ECO mode.
33
Remedy
Remedy
Remedy