Cleaning Areas Covered By The Toilet Seat Lid & Unit - American Standard INAX SpaLet Manuel D'installation Et De L'utilisateur

Cleaning Areas Covered by the Toilet Seat Lid & Unit
When cleaning this product, be sure to unplug the power plug from the wall outlet.
CAUTION
Removing the toilet seat lid
1. Move the pin hole on the right side
of the toilet seat lid to the outside and
remove it from the pin.
Toilet seat lid
1. Remove the power plug from the
wall outlet.
2. Close the water shutoff valve to
cut off the water supply.
Pin hole
Pin
4. Carefully place the seat unit on the rim of the
Fit together.
toilet bowl.
5. To reinstall seat, slide it back on mounting pad.
Slide
forward
Pin hole
Pin
Move to the outside.
Removing the seat unit
3a. Push the lock lever on the right side of the seat unit.
3b. Pull from base of seat, slide the seat forward by grasping at base,
raise it slightly and remove from toilet.
Toilet seat lid
" " mark on the mounting plate
2. Hold the toilet seat up on the right
side and slide it to the left, removing it
from the pin on the left side.
If you try to pull hard to remove the toilet seat
CAUTION
lid, it could crack or break.
Slide
Water
shutoff valve
Turn clockwise.
3b
Slide
forward
Lock lever
CAUTION
When cleaning the toilet bowl, take care not to splash
the seat unit with detergent. Before installing the seat
unit, wipe the detergent off from the toilet bowl using a
cloth damped with water.
* Do not reverse * Do not pull.
* Do not place on
the floor.
31
Lift up
Wipe o here.
3a
* When removing this
product, slide the unit
slowly without holding
the toilet seat or toilet
seat lid. Do not use
excessive force.
Slide
forward