Additional Important Information - American Standard INAX SpaLet Manuel D'installation Et De L'utilisateur

Additional Important Information

• The capacity of the warm water tank is 0.88 L.
Water temperature gradually drops when rear
cleansing or front cleansing is used. If the water
drops below a comfortable temperature, press
the stop button and wait about 3 minutes for the
water to reheat.
• T he water temperature range is preset to the
following temperatures:
Low: Approx. 90 °F (32 °C),
Medium: Approx. 93 °F (34 °C),
High: Approx. 97 °F (36 °C).
It takes approximately 10 minutes to heat cold
water (at about 41 °F [5 °C]) to the appropriate
temperature (about 100 °F [38 °C]).
This product is designed to use the tap water
pressure to extend the nozzles and spray water
through them. When the tap water pressure is
extremely low, the nozzles may not spray water
at all when the water pressure is set to the
lowest setting. If this occurs, adjust the Spray
Strength.
When the toilet is new, a slight odor may come
from the deodorizer. This will go away in a short
time.
Before and after cleansing and when the water
temperature adjustment button is pressed, etc.,
water is sprayed from the nozzle. This occurs by
design and is not a cause for concern.
If water sprays while under any other
configuration, or sprays constantly, close the
water shutoff valve and remove the power plug
from the wall outlet. Then, contact cutomer
service.
This product is equipped with a seat sensor that
prevents the water from spraying if nobody is
sitting on the toilet seat. This prevents activation
if the Bidet button is pressed when the toilet seat
is unoccupied.
18