General Information; General Identification; Safety Features - McCulloch EAGER BEAVER EB428 Manuel D'utilisation

26

1-1.GENERAL IDENTIFICATION

1. GUIDE BAR
2. SAW CHAIN
3. SAW CHAIN ADJUSTMENT SCREW
4. SPARK ARRESTER SCREEN
5. CHAIN BRAKE® LEVER /HAND GUARD
6. FRONT HANDLE
7. STARTER HANDLE
8. SPARK PLUG
9. AIR CLEANER COVER
10. STOP SWITCH
11. SAFETY LATCH
12. OIL TANK CAP
13. STARTER COVER
14. FUEL TANK CAP
15. REAR HANDLE / BOOT LOOP
16. PRIMER BULB
17. BLUE CHOKE LEVER
18. BAR RETAINING NUT
19. THROTTLE / TRIGGER
20. CHAIN CATCHER
21. MUFFLER SHIELD
22. CLUTCH COVER
23. BUCKING SPIKE
24. CLUTCH COVER RETAINING SCREW
25. SCREWDRIVER / WRENCH
26. CARRY CASE (Available on some models)

1 - GENERAL INFORMATION

25
17
11
15
19
1
2
8
21
9
22
24

1-2. SAFETY FEATURES

Numbers preceding the descriptions correspond with the
numbers above to help you locate the safety feature.
2 LOW KICKBACK SAW CHAIN helps significantly
reduce kickback, or the intensity of kickback, due to
specially designed depth gauges and guard links.
4 SPARK ARRESTER SCREEN retains carbon and
other flammable particles over 0.023 inches (0.6mm)
in size from engine exhaust flow. Compliance with
local, state and federal laws and/or regulations gov-
erning the use of a spark arrester screen is the user's
responsibility. See Safety Precautions for additional
information.
5 CHAIN BRAKE
operator's left hand in the event it slips off the front
handle while saw is running.
5 CHAIN BRAKE
the possibility of injury due to kickback by stopping a
moving saw chain in milliseconds. It is activated by the
CHAIN BRAKE
10 STOP SWITCH immediately stops the engine when
tripped. Stop switch must be pushed to ON position to
start or restart engine.
11 SAFETY LATCH prevents accidental acceleration of
the engine. Throttle trigger (19) cannot be squeezed
unless the safety latch is depressed.
20 CHAIN CATCHER reduces the danger of injury in the
event saw chain breaks or derails during operation.
The chain catcher is designed to intercept a whipping
chain.
3
4
23
12
5
3
18
20
® LEVER / HAND GUARD protects the
® is a safety feature designed to reduce
® lever.
6
7
10
16
14
13