Table des Matières
Publicité
7.
Install the Hanger Bracket
Hanger Bracket
Support d'ancrage
Soporte de suspensión
Bolt
Boulon
Blind Nut
Perno
Écrou borgne
Tuerca ciega
Bushing
Bague
Buje
Roller
Rouleau
Rueda
Insert a bushing into one of the holes at the top of one of the glass panels.
Install a hanger bracket over the glass panel with the mounting hole aligned with
the bushing.
Insert a blind nut through the hanger bracket hole and bushing. Secure with a
bolt.
Repeat the procedure with each hanger bracket on the door panels.
NOTE: The steel side of the roller must be installed against the hanger bracket.
NOTE: There is a label on the each glass panel identifying the "Non-coated side" of
the panel.
Use #8-32 x 3/8" panhead screws to attach two rollers on each glass panel. The
rollers on one glass panel should be installed on the "Non-coated side" of the
door. This will be the outside panel. The rollers on the other door panel should be
installed opposite the "Non-coated side" of the door panel. This is the inside
panel.
Installer le support d'ancrage
Insérer une bague dans un des orifices au dessus d'un des panneaux en verre.
Installer un support d'accrochage sur le panneau en verre avec l'orifice de
montage aligné avec la bague.
Insérer un écrou borgne dans l'orifice de support d'accrochage et dans la bague.
Sécuriser avec un boulon.
Sterling
Roller Steel Side
Côté rouleau en acier
Lado de acero de la rueda
#8-32 x 3/8" Screw
Vis #8-32 x 3/8"
Tornillo del #8-32 x 3/8"
15
Hanger Bracket
Support d'ancrage
Soporte de suspensión
1063216-2-E
Publicité
Table des Matières
