Long Term Storage - Stanley ST-70-SS-E Guide D'utilisation

Maintenance
NEVER OpERATE THIS HEATER UNATTENDED! Use
only original equipment replacement parts. The use of
alternate or third party components can cause unsafe
operating conditions, and will void your warranty. We
suggest following a maintenance schedule as follows:
Filters - The Fuel Filter and Oil Filter should be cleaned at
least twice per heating season.
Fan Blades - The fan blades should be cleaned at least
once per heating season, depending on conditions.
Spark plug - Clean and re-gap every 600 hours of
operation, or replace as needed.
photocell - The Photocell should be cleaned at least once
per heating season or more depending on conditions.
Fuel/Fuel Tank - Flush every 200 hours of operation or as
needed.
problem
Heater fires, but shuts down after a short
period of time.
Heater will not operate, or motor runs for
short time.
Fan does not operate when heater is
plugged in and Operating Switch is in the
"ON" position.
Heater makes grinding noise.
Heater does not turn on and the lamp is
not lit.
STANLEY and
© 2013, Pinnacle Products International, Inc.
Troubleshooting
possible Cause
1. Dirty Fuel Filter.
2. Nozzle Dirty.
3. Photocell Dirty.
4. Photocell not installed properly.
5. Photocell Defective.
1. No fuel in fuel tank.
2. Corroded Spark Plug or incorrect plug
gap.
3. Dirty Fuel Filter.
4. Dirty Nozzle.
5. Moisture in Fuel/Fuel Tank.
6. Transformer Wires not connected to
Spark Plug.
7. Defective Transformer.
1. Broken electrical connection between
Circuit Board and motor.
2. Not enough amps available to power
heater.
1. Air in fuel pump.
1. Temperature limit sensor has over-
heated.
2. No electrical power.
3. Fuse break down.
4. Improper electrical connection between
Temperature Limit Sensor and Circuit
Board.
are trademarks of Stanley Black & Decker, Inc or its affiliates and are used under
license by pinnacle products International, Inc.

Long Term Storage

-
Unscrew the Fuel Cap, and using an approved fuel
siphon, remove paraffin or diesel.
-
Using a small amount of paraffin or diesel, rinse and
swirl the fuel inside of the Fuel Tank. Empty the tank
fully.
-
NEVER MIX WATER WITH FUEL, as it will cause rust
inside the tank.
Never store leftover paraffin or diesel over the
summer. Using old fuel can damage your heater.
Store heater in a dry, well-ventilated area
1. Clean/replace Fuel Filter.
2. Clean/replace Nozzle.
3. Clean/replace Photocell.
4. Adjust Photocell position.
5. Replace Photocell.
1. Fill tank with fresh fuel.
2. Clean/replace Spark Plug.
3. Clean/replace Fuel Filter.
4. Clean/replace Nozzle.
5. Rinse out tank with clean fresh fuel.
6. Re-attach Transformer wires to Spark
7. Replace Transformer.
1. Inspect all electrical connections on
2. Use a new extension cord or try
1. Sound will stop after 3 seconds. If
1. Push Operating Switch to "OFF" and
2. Check power cord and extension cord.
3. Check/replace Fuse.
4. Inspect all electrical connections.
11
Solution
Plug.
Wiring Diagrams.
another electrical socket.
grinding sound continues, add fuel to
tank.
allow heater to cool for 5 minutes.
Test power supply.