Function Selection - CAME ZL90 Manuel D'installation

Adjustment Trimmer
G
Trimmer ACT
Trimmer DELAY 2M
Trimmer -- SENS -- RUN
Trimmer -- SENS -- SLOWING
Trimmer -- SPEED -- RUN
Trimmer -- SPEED -- SLOWING

Function Selection

F
1 OFF Enables the obstacle stand-by or partial stop function; connect the safety device to terminals [2-CY]. If device is unused, set
the DIP switch to ON;
1 OFF - 2 ON Obstacle stand-by – stops the gate when there is an obstacle is detected by the safety device; once the obstacle has
been cleared, the gate is automatically set back in motion to finish initial run. Connect the safety devices to terminal
[2-CY];
1 OFF - 2 OFF Partial stop – stops gate when an obstacle is detected by the safety devices; once the obstacle is cleared, the gate
remains still or closes if the automatic closing function is enabled. Connect the safety devices to terminal [2-CY];
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
Adjusts the waiting time when gate is open. Once this time has elapsed, the gate closes automa-
tically. The waiting time can be adjusted anywhere between 1 and 150 seconds.
Adjusts the waiting time of the second motor during each closing run. The waiting time can be
adjusted anywhere between 1 and 16 seconds.
Adjusts the amperometric sensibility which controls the power developed by the motor during
motion; if the power exceeds the adjusted level, the system sets in motion to invert the direction
of motion.
Adjusts the amperometric sensibility which controls the power developed by the motor during
slowing downs; if the power exceeds the adjusted level, the system sets in motion to invert the
direction of motion.
Adjusts the gate-leaf running speed when opening or closing.
Adjusts the gate leaf's slowing speed at the end of the stroke when opening and closing.