Installation - Tripp-Lite B002-DP1A4 Manuel De L'utilisateur

Important Safety Instructions
• This device is equipped with a three-wire grounding-type plug. This is a
safety feature. If you are unable to insert the plug into the outlet, contact
an electrician to replace your outlet with one that will accept this type of
plug. Do not attempt to defeat the purpose of the grounding-type plug.
Always follow your local/national wiring codes.
• Warning! There is a risk of explosion if the battery is replaced with
an incorrect battery type. Do not attempt to service the device
yourself. Refer all servicing to qualified service personnel.

Installation

Note: Before proceeding with installation, make sure all devices being connected to
the KVM switch are turned off.
1. Using audio/video cables appropriate for your switch model, connect the
video output port of each computer you are adding to the video input
ports of the KVM Switch.
Note: Models with Dual Monitor capability require two available video ports per
computer.
2. Using USB A/B device cables, connect a USB port on each computer
being added to the USB input ports of the KVM Switch.
Note: Models with CAC (Common Access Card) support require an additional USB
2.0 A/B cable connected to each computer.
3. Using 3.5 mm stereo audio cables, connect the audio output of each
computer you are adding to the audio input ports of the KVM Switch.
4. Using the appropriate audio/video cable, connect a monitor appropriate
for your switch model to the console video output port of the KVM
switch.
18-06-346-933846.indb 8
8
8/14/2018 5:53:59 PM